I'm very happy that SeaDAS 5.1.6 was released and have immediately
downloaded and installed it.

However, when I was trying to load the nLw_443 data of CZCS Level
3(ex. C1978303.L3b_DAY.main), in SeaDAS command mode,

I got the following error:
------------------------------
seadisp
load, '/data/czcs/l3/daily/C1978303.L3b_DAY.main',$
　　　　 prod_name= ['nLw_443']
------------------------------

<error message>

SeaDAS Version 5.1.6 (pid = 18983)
Detected CZCS ftype.
Getting special lat/lon from HDF file...

grp_name = Level-3 Binned Data.

% Array dimensions must be greater than 0.
% Execution halted at: OLD_PROD_CAT_DEFAULTS   16
% /home/wataru/seadas516/idl_lib/old_prod_cat_defaults.pro
%                      SDP_READ_CZCS      18
%                      /home/wataru/seadas516/idl_lib/sdp_read_
czcs.pro
%                      LOAD             1075
%                      /home/wataru/seadas516/idl_lib/load.pro
%                      $MAIN$
------------------------------

Unfortunately, I could not figure out the solution.

Any help would be appreciated!
Thanks a lot!

wataru

I am using ...
1)  SeaDAS version : 5.1.6
2)  Operating system : Linux 2.6.11-1.1369_FC4smp #1 SMP Thu Jun
                               2 23:08:39 EDT 2005 i686 i686 i386 GNU/Linux
3)  SeaDAS distribution : seadas_fedcore4.tar.gz
4)  Version of IDL : IDL 6.4

Wataru,

Just modified the SeaDAS codes to enable command load
CZCS L3bin files. This fix is only good for current SeaDAS 5.1.6 version.

If you have your own fully licensed version of IDL, then you can download
the file, put it in your SeaDAS idl_lib directory and give a try:

  ftp://samoa.gsfc.nasa.gov/seadas/pub/l3bin/load.pro

Long

Long,

Thank you for your reply.  The modified load.pro is working very well.

Best regards,
wataru